Cornelius ICE FROST Betreibershandbuch PDF herunterladen (Seite 10)

Ice Frost Operator’s Manual

“FILTER CLEANING” Alarm

A filter cleaning alarm will activate when the unit is running hot due to insufficient internal air circulation.

When this occurs a “Filtr” message will appear on the touch pad LED display readout and an intermittent

audible tone will also sound to alert the operator of this condition.

The “Filtr” message will appear when the alarm activates (a beeping sound every 4-5 seconds). To

determine the condition that caused the alarm and correct problem, see list of conditions below:

“SYSTEM OVER TEMPERATURE” Alarm

A system over temperature alarm will activate as a safety precaution when the unit has overheated to

protect the compressor.

• The system automatically goes to “OFF” status where the compressor’s operations is stopped, while

augers will keep working to avoid forming ice blocks.

• When this occurs an “Err” message will appear on the touch pad LED readout accompanied by a

continuous buzzer sound to alert the operator of this condition.

• When this alarm activates, turn OFF all switches. Then determine the condition. (See “Filter Cleaning”

Alarm Section for Conditions and Corrective Actions).

ICE FROST GENERIC (PRE-MIX)

WARRNING: If the unit runs out of product, is turned off and turned back on without a new

(full) product tank installed the sensor will look for product for 4 minutes. During this 4

minute period CO

will be pumped into the air.

Condition Corrective Action

• The filter is dirty and needs to be cleaned. • Clean and replace filter following instructions

(Removing and Cleaning Filter).

• The unit is positioned too close to a wall or

other object restricting air flow and causing

the machine to run at a higher temperature.

• Reposition unit to maximize ventilation space

(Installation Instructions).

• The filter is not properly installed. • Properly install filter (Removing and cleaning fil-

ter).

• The unit has been installed near a heat

source, such as a coffee machine, ice maker

or cold beverage machine which expels hot

air from its vents, causing the machine to run

at a high temperature (installation near a

heat source should be avoided).

• Reposition unit to maximize ventilation space.

• Switch the machine’s main switch to the ON position (1).

• Put the switch (A) into the ON position (1) see Figure 5,

switch A. Controls the flow of the product in the bowls.

• The machine’s bowls will now fill up until the maximum level

is reached.

• Continue with start up operations.

FIGURE 5

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Cornelius ICE FROST Betreibershandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mixer Cornelius ICE FROST