Cornelius 2000 - Series Installationshandbuch PDF herunterladen (Seite 11)

638085277

INSTALLATION INSTRUCTIONS

A.. REMOVE ICEMAKER FROM CARTON:

1. Keep unit in the upright position, remove carton and pallet from unit and inspect unit for damage. Upon

inspection of unit, if any damage is found, file a claim with carrier immediately.

2. Locate Startup Card either on outside of container or on plastic liner. Fill in proper information and

send one copy to factory, and other copy to Distributor. Postage is prepaid.

B.. CABINET REMOVAL

1. Locate and remove the (2) screws from under the front cover. Lift cover forward and up to remove.

2. Lift up front edge of top cover. Slide back about 1/2 inch and remove.

3. Remove (6) screws from the front of the machine.

4. Remove side panels by sliding the front edge out and then back slightly to disengage.

5. Remove the front splash panel by lifting slightly to disengage the front, then tilt forward and remove.

6. Remove bin top and remove shipping insert.

C.. PREPARATION OF INSTALLATION SITE

1. The refrigeration system on air cooled units requires airflow, so a well ventilated area should be cho-

sen. A minimum of (6) inches must be maintained, free of any obstruction, for air intake. A minimum of

(4) inches clearance is required for air exhaust.

2. With template provided make the necessary provisions in the counter for water, drain and the electrical

hook–up. Provisions are available for rear and bottom connections of water and electrical. Use hole

plugs provided to plug unused holes.

D.. WATER INLET HOOK–UP:

1. Water Inlet – Fitting is a 1/4” SAE male flare located at the rear of the unit. Connect water supply with

a 1/4”or larger copper or flexible tubing.

2. Water Pressure – Unless otherwise specified, the unit is designed to operate on water pressures be-

tween 10 P.S.I. and 90 P.S.I. (NOTE: for pressures above 90 P.S.I. a regulator must be installed).

3. Water Cooled Condensers

a.. Inlet to modulating valve uses 3/8” FPT. Use separate 3/8” or larger water line.

b.. Outlet is 3/8” FPT.

4. Filter Conditioners are recommended on supply lines to icemakers. Never run the water supply to wa-

ter cooled Condenser through Filter/Conditioner, it uses up the cartridge unnecessarily and a saturated

cartridge can starve the icemaker causing premature component damage. Separate water supplies

are recommended.

NOTE: Unit must be installed per local plumbing code.

E.. ELECTRICAL SUPPLY

1. Power Access – Is provided by way of a 7/8” dia. hole in both the base and the rear panel. Route in-

coming power in conduit, to icemaker electrical control box. Make connections to wires provided in

control box and ground lug/screw. Plug unused hole.

2. Fused Line – Should be a dedicated circuit checked and sized according to electrical rating shown on

unit nameplate.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 65 66

Keine Kommentare

Cornelius 2000 - Series Installationshandbuch Seite 11