Cornelius Xtreme 330 Series Spezifikationen PDF herunterladen (Seite 23)

630460146

October 27, 2003

BEFORE CALLING FOR SERVICE

If a problem arises during the operation of your ice machine, follow the checklist below before calling for ser-

vice.

CHECKLIST

Problem Probable Cause Remedy

ICE MACHINE DOES NOT

OPERATE

A. No electrical power to ice

machine.

A. Replace fuse, reset circuit

breaker, turn on main switch.

B. Tripped high pressure cutout. B. Reset high pressure cut-out.

C. ON switch set improperly. C. Set switch at ON.

D. Water curtain stuck open. D. Water curtain must swing freely.

ICE MACHINE STOPS AND

CAN BE RESTARTED BY

TURNING POWER SWITCH

OFF THEN BACK ON AGAIN

A. Safety limit feature stopping

ice machine.

A. Refer to safety limit feature.

ICE MACHINE DOES NOT

RELEASE ICE OR IS SLOW

TO HARVEST

A. Ice machine evaporator dirty. A. Clean the evaporator, the water

system and sanitize ice machine.

B. Ice machine not level. B. Level ice machine.

C. Air–cooled models: low

ambient.

C. Minimum ambient is 50_F .

D. Water regulating valve leaking

during harvest mode

(water–cooled ice machines).

D. Refer to water–cooled condenser.

POOR QUALITY ICE. (ICE

SOFT OR NOT CLEAR)

A. Quality of incoming water. A. Contact qualified service

company to test quality of water

and make appropriate filter

recommendations.

B. Water filtration element needs

to be changed.

B. Replace filter.

C. Ice machine dirty. C. Clean and sanitize ice machine,

pages 5 & 6.

D. Water dump valve not working. D. Disassemble and clean the water

dump valve.

E. Water softener working

improperly (if installed).

E. Repair water softener.

SAFETY LIMIT FEATURE

In addition to standard safety controls such as the high pressure cut-out, your ice machine features built-in safe-

ty limits that stop the ice machine if conditions exist that may result in a major component failure.

Before calling for service, restart the ice machine using the following procedures:

1. Turn power switch off and then back to “ON” position. If the safety limit feature has stopped the ice machine,

it will restart after a short delay. Proceed to Step 2, but if the ice machine does not restart, refer to “Ice Ma-

chine Does Not Operate” in the problem checklist.

2. Let the ice machine operate to determine if the condition recurs...

a. If the ice machine stops again, the condition recurred; call for service.

b. If the ice machine continues to run, the condition corrected itself; let the machine run.

1 2 ... 18 19 20 21 22 23 24 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Cornelius Xtreme 330 Series Spezifikationen Seite 23

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Cornelius Xtreme 330 Series