Cornelius I Series Spezifikationen PDF herunterladen (Seite 11)

TP00952

November 26, 20016

DISPENSER INSTALLATION

1. Order the proper cuber/dispenser adaptor kit. This package include gasket material, a hold-down

bracket, and bin stat kit (contact service provider for more information).

2. RTV applications (See Figure 3). If the ice bin is full, new ice will not be able to drop. Instead it

blocks the evaporator curtain open and no additional ice is made. This new ice may start to melt and

the resulting liquid can leak out of the joint between the ice maker and bin. To prevent this problem,

seal the joint with food grade silicon sealant.

FIGURE 3

3. Install Bin stat, Part No. 630000408 (See Bin Stat Kit Instructions).

Figure 4 is an example of a typical electical and plumbing connection.

AIR-COOLED MODELS

WATER-COOLED MODELS

Electrical Service Line

Manual Disconnect

Switch

STRAIN RELIEF

MUST BE USED

Water Filter

Shut-Off Valve

Dump

Valve

Drain

Tube

Bin Drain

Tube

*Air Gap 4”

“minimum”

Electrical Service Line

Manual Disconnect Switch

Shut-Off Valve

Water Filter

Shut-Off Valve

Condenser Water Inlet

Dump Valve

Drain Tube

*Air Gap 4”

“minimum”

Bin Drain

Tube

Condenser Water

Drain Tube

Strain Relief

must be used

Floor Drain

FIGURE 4

* An air gap of at least twice the diameter of the water supply inlet plus a minimum of 1” (25 mm) must

exist between the floor drain and drain tube.

NOTE: Leave all panels on the cuber until it is in place on the bin.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare

Cornelius I Series Spezifikationen Seite 11

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Eiswürfelmacher Cornelius I Series